CNC kit-3Axis Nema34 Stepper Motor 1232OZ-In,5.6A&Driver DQ860,7.8A

Description

This Item includes:
3PCS Nema34 Stepper Motor WT86STH118-6004A with 1232oz-in holding torque,5.6A current,118mm motor body length,Single shaft
3PCS Driver DQ860MA with 7.8A peak current ,24-80VDC ,256 Microstep
3pcs power supply:350W  60V
1 pc breakout board&cable is
free offered
1, Stepper Motor
Technical Specifications
Part No.:                      WT86STH118-6004A
Frame Size:                  NEMA34
Step Angle:                  1.8 degree
Voltage:                       3.6V
Current:                       5.6A/phase
Resistance:                  0.6 Ohm/phase
Inductance:                  6.5 mH/phase
Holding torque:            8.7N.m            1232oz-in
Rotor inertia:                2700g-cm2
Number of wire leads:  4
Weight:                        3.8 kg
Length:                        118mm
Note: Nema 34 Stepper Motor with 1232oz-in holding torque on  single shaft, the diameter for motor shaft is 14mm.
RED            A+
GREEN       A-
YELLOW    B+
BLUE          B-
Please tell us if you need Double shaft or single shaft, we can manufacture both for you. If you need Double shaft, please tell us your requirements for length of front and rear shaft, as well as the diameter. So that we can offer you the quite good products, thanks!
2, Stepper Motor Driver DQ860MA
DQ860MA
Introduction,Features and Applications
Introduction
The DQ860MA is  an economical microstepping driver based on patented technology of Wantai Motor .It is suitable for driving 2-phase 4-phase hybrid stepping motors .By using the advanced bipolar constant-current shopping technique ,it can output more speed and torque from the same motor,compared with traditional drivers ,such as L/R drivers .Its 3-state current control technology allows coil currents to be well controlled and with relatively small current ripple,therefore less motor heating is achieved.
Features
◆
Low cost and good high-speed torque
◆14 selectable resolutions
◆Supply voltage up to +80VD
◆Suitable for-2-phase and 4-phase motors
◆Output current up to 7.8A,5.6A rated current
◆Dip switch current setting 8different values
◆Optically isolated input signals
◆Pulse frequency up to 200KHz
◆Automatic idle-current reductiOn
◆Small size  (107*97*48),Weight:500G
3, Power Supply 350W,60VDC
4, Breakout Board DB25
Description:
Built in DB25 male connector.
DB25 Output Pin:P1,P2,P3,P4,P5,P6,P7,P8,P9,P14,P16,P17.
DB25 Input Pin: P10,P11,P12,P13,P15.
DB25 GND Pin: P18-P25.
Power supply: +5V DC.
Built in C-class Optical-coupler.
High quality with Surface-mount Tech.
We ship worldwide!
Our Products are mainly used in robotization, Spinning Automatization, Printing, Packing, Medica   Machine, Make-up Equipment, Communication,    Household Appliance, Water Pump, Milling Machine, Engraver Machine, CNC Routers.. etc automatic equipment of various trades.